I have been waxing my own eyebrows for years now! I don’t even go to salon to get them done because a.) they way over charge you and b.) I can get them exactly how I like if I do it myself
This will be a picture tutorial of how I wax my own eyebrows
These are the only products I use to wax my eyebrows. You can find the wax I use here:
I use popsicle sticks to apply it because its clean and cheap. Just make sure you use a new one each time 🙂
Microwave the jar (lid off) on high. I usually start with 1 minute then add a minute until it begins to melt. Once it starts to melt I add 30 seconds until it is completely melted. When It is fully melted you are good to go! Check the temperature on your wrist to make sure it won’t burn you.
I always check with one of the popsicle sticks to make sure I have the right shape I want. From the outside of your nose to the inner corner of your eye should be where the eyebrow starts. Looking straight ahead, the outside of your nose to the middle of your pupil should be the highest point of the arch. The outside of your nose to the outer corner of your eye should be the end of the brow.
Once you have the shape you want, apply the wax. (in small amounts) Only put the wax where there are stray hairs. If you have a lot of hair you’d like gone, you can take a white eyeliner and mark the areas you’d like to be waxed.
If there are a few spots that need touching up, you can always grab a handy tweezer!
Thanks for reading! I hope I helped you in some way. Do you wax or tweeze your own eyebrows? Tell me about it in the comments!
Check out my new tutorial on how I trim and fill in my eyebrows!